Beaded in Brass Base - Wire Tree Sculpture
5" x 5"x 4" The tree is made of 24 and 26 gauge steel wire with parts of the trunk rusted to a soft brown color. Woven into the branches are yellow green and white fringe beads. The tree is bonded into a round tarnished brass base using sea sand and small pebbles and a small rock. The sea sand is painted yellow and green India ink to look like moss covered earth.

This 25" wall sculpture was hammer formed from 16 gauge copper sheet metal. This is one of a series of wall relief sculptures I have made based on coral formations, using the process of repousse and chasing.

Wire tree sculpture with hammered leaves. 17" wide x 28" high. Created using 18, 24 and 26 gauge steel galvanized wire. The hundreds of leaves are created by hammering flat every end of every wire, the flattened leaves are then hand painted in several shades of green using enamel paint. The fully exposed root system is set into a beautifully hand painted floral design 7" round ceramic pot. The tree sculpture is permanently bonded into its base using a mixture of mortar, white glue, sea sand, pebbles and small rocks. The sand is painted in shades of green and yellow, using India ink, giving the appearance of a moss setting. This sculpture can be displayed in direct sunlight. All the coloring agents used are light fast, and will not fade.

10" X 11" X 8" Made of 24 and 26 gauge galvanized steel wire. The tree
is planted into a brass 4" round top base using sea sand and pebbles.
The sea sand is painted in yellows and greens using India ink to look