ArtMetal home page
ArtMetal TechTalk
Forums
User:  guest      

Re: metal bender instructions and helpHits: 3347
Dave Brown [quahogwi]
on 04/21/02 09:39am
[     ]
     
john niolon wrote:
> So I'll start with a question. I recently bought a Harbor Freight (hossfield knockoff) compact bende ...... but the right angle attachment (the one I need badly) has me stumped... can anyone offer any advice,instruction, comments or help with this unit.


You are right about the poor instructions and the instructions for using the right angle bender are the worst. It took a while for me to figure it out also, but I finally did. They say a picture is worth a thousand words, but this one could use two pictures. So, here's the fist picture showing the basic setup for right angle bending with a piece of 1/8"x3/4" flat bar in place. I'll post a second picture right after this one.

So, without further ado, here's picture #1.

Dave 


  Subject Author Date
  metal bender instructions and help john niolon 08/11/01 03:01pm
  Re: metal bender instructions and help Rick L 08/20/01 07:21pm
  Re: metal bender instructions and help travis hamilton 04/21/02 09:12am
*  Re: metal bender instructions and help Dave Brown 04/21/02 09:39am
  Re: metal bender instructions and help James Happe 04/21/02 03:29pm
  Re: metal bender instructions and help Dave Brown 04/21/02 09:45am
  Re: metal bender instructions and help john niolon 04/22/02 07:48am
Jump to :

Search TechTalk forums or try searching the ArtMetal site by clicking here!

Community News

© copyright 1997-2006 all rights reserved ArtMetal