wire

Dark Copper Oak, wire tree sculpture

Sal Villano — Sat, 27 Feb 2010 03:03:53 -0600

7"H x 5"W x 6"D Created using 24 and 26 gauge solid copper wire. The trunk and the root system are cotaed and will retain a glossy appearance. The branches and the twigs are untreated copper and will darken and petina with age.

Gold Wind Swept, wire tree sculpture

Sal Villano — Sat, 16 Jan 2010 10:36:01 -0600

8" x 8" x 5" Made of 24 Gauge Gold color wire. Planted in a dark blue ceramic rectangular bonsai pot. The tree is on a mound of bonded sea sand and pebbles which have been painted with green and yellow India ink to look like moss covered earth.

Oriental Bonsai, wire tree sculpture

Sal Villano — Mon, 04 Jan 2010 16:55:43 -0600

Wire tree sculpture with hammered leaves. 17" wide x 28" high. Created using 18, 24 and 26 gauge steel galvanized wire. The hundreds of leaves are created by hammering flat every end of every wire, the flattened leaves are then hand painted in several shades of green using enamel paint. The fully exposed root system is set into a beautifully hand painted floral design 7" round ceramic pot. The tree sculpture is permanently bonded into its base using a mixture of mortar, white glue, sea sand, pebbles and small rocks. The sand is painted in shades of green and yellow, using India ink, giving the appearance of a moss setting. This sculpture can be displayed in direct sunlight. All the coloring agents used are light fast, and will not fade.

Coral Wind Swept, wire tree sculpture

Sal Villano — Mon, 28 Dec 2009 11:57:34 -0600

12" X 11" X 8" Created using 24 and 26 gauge galvanized steel wire. The tree is mounted onto an irregular shaped piece of white coral. The coral is mounted onto a 7 inch square piece of translucient piece of

Cedar on Base, wire tree sculpture

Sal Villano — Mon, 28 Dec 2009 11:53:40 -0600

10" X 11" X 8" Made of 24 and 26 gauge galvanized steel wire. The tree
is planted into a brass 4" round top base using sea sand and pebbles.
The sea sand is painted in yellows and greens using India ink to look

Hello, Im new, heres my eagle sculpture

martin1980 — Mon, 06 Apr 2009 15:54:28 -0500

Hello everyone, this is something ive been working on since last summer. I made it by mig welding 2 - 4mm stainless steel bars together, to create a see through structure that has the look of feathers. I just got it back from electropolishing, and it gleams beautifully, inside and out. The eyes are stainless spheres which i chopped up and mounted. eagle side vieweagle faceeagle overheadeagle front on

face being built

martin1980 — Mon, 06 Apr 2009 15:53:13 -0500

Antinous

martin1980 — Mon, 06 Apr 2009 15:50:21 -0500

eagle front on

martin1980 — Mon, 06 Apr 2009 15:48:29 -0500

eagle overhead

martin1980 — Mon, 06 Apr 2009 15:43:38 -0500