drawing

Finally found my cheap, dumb CAD program!

Rich Waugh — Sun, 12 Feb 2012 09:03:48 -0600

For years now I've been using an old legacy CAD program to do my mechanical drawings and job sketches, but it won't run on Windows 7 64-bit at all and is badly wonky on 32-bit. Over time I've gotten really comfortable with it and all the other CAD programs I've tried out had too long a learning curve for me, so I had to set up a separate computer just run that old program. Until now.

augmented landscape IV

matyou galea — Wed, 24 Aug 2011 07:20:22 -0500

Twist Variants / Drawing

Pezzi — Tue, 01 Jun 2010 15:31:39 -0500

This drawing was taken from Jerry Hoffman's Blacksmith Journal.

No.8 appeals to me most for the start of another diamond twist:

*I would flatten the four corners somewhat and then pound in wide chisel cuts on all the corners.

hand Rail Design

R L Sidebottom — Thu, 12 Feb 2009 13:39:03 -0600

Here is a drawing I did for a small 3 step hand rail. Space constraints drove the design size pretty hard. I'm just waiting on approval and some help. Mostly approval, help is pretty easy right now.

Valentin Yotkov Studio update

vyotkov — Sun, 21 Dec 2008 10:02:57 -0600

Dear friends,

It's been a busy year at that Valentin Yotkov Studio and as the year comes to an end, I am elated to announce that the studio will remain open a bit longer. For how long is still unknown.