railings

A another shot of the railing It's finally delivered and partally installed

R L Sidebottom — Wed, 30 Apr 2008 21:25:30 -0500

I finally had a chance and some decent weather to deliver and start installed a railing that has been waiting for months. I was a little afraid that they would not like the finish or the design. They were not home when I delivered it and measured for the hand rails.

haney railing 2

R L Sidebottom — Wed, 30 Apr 2008 21:25:00 -0500

Haney Railing

R L Sidebottom — Wed, 30 Apr 2008 21:23:15 -0500

tight to the rules

Giusseppe — Sat, 12 Apr 2008 12:21:34 -0500

Back in the '80s I loved to keep the building inspectors on their toes ..... here is one of my first stainless railings for the City of London ..... obeys the 4 inch ball rule, withstands the necessar

Blackfriars railings detail

Giusseppe — Sat, 12 Apr 2008 12:21:01 -0500

lumps pushed into lumps

Blackfriars railings

Giusseppe — Sat, 12 Apr 2008 12:19:06 -0500

minimum horizontals

Canary Wharf Railings2

Giusseppe — Sat, 12 Apr 2008 12:05:03 -0500

sketch for canary wharf railings

Canary Wharf Railings1

Giusseppe — Sat, 12 Apr 2008 12:02:55 -0500

corner detail

A railing that I have been working on

R L Sidebottom — Sun, 02 Mar 2008 23:03:40 -0600

This is one side of a handrail that I have been working on. Now just waiting on good weather to install it. There are 2 hand rail that go with it. I have to wait to get the railings installed to fit the hand rails.

Rose garden fence sample flowers

eligius1427 — Fri, 15 Feb 2008 23:02:05 -0600

Hi all,

Here are a few photos of a sample I just finished for some fencing around the Lincoln City Rose Garden which is getting a giant facelift. The design came from the landscape architect running the project and kind of has an art deco feel to it. The leaves and petals were cut with a plasma cutter and then forged to their final shape. I used the large ladle dish in a green-mengal B swage block to form the rose and I textured the vine by carving lines into an old hammer and using it on 1"x1/2" solid bar stock. I'll post a few picts when I start fabricating the panels.