how to book

Dark Copper Oak, wire tree sculpture

Sal Villano - Saturday, February 27, 2010 - 5:03am

7"H x 5"W x 6"D Created using 24 and 26 gauge solid copper wire. The trunk and the root system are cotaed and will retain a glossy appearance. The branches and the twigs are untreated copper and will darken and petina with age.

» read more | login or register to post comments

Oriental Bonsai, wire tree sculpture

Sal Villano - Monday, January 4, 2010 - 6:55pm

Wire tree sculpture with hammered leaves. 17" wide x 28" high. Created using 18, 24 and 26 gauge steel galvanized wire. The hundreds of leaves are created by hammering flat every end of every wire, the flattened leaves are then hand painted in several shades of green using enamel paint. The fully exposed root system is set into a beautifully hand painted floral design 7" round ceramic pot. The tree sculpture is permanently bonded into its base using a mixture of mortar, white glue, sea sand, pebbles and small rocks. The sand is painted in shades of green and yellow, using India ink, giving the appearance of a moss setting. This sculpture can be displayed in direct sunlight. All the coloring agents used are light fast, and will not fade.

» read more | login or register to post comments

Coral Wind Swept, wire tree sculpture

Sal Villano - Monday, December 28, 2009 - 1:57pm

12" X 11" X 8" Created using 24 and 26 gauge galvanized steel wire. The tree is mounted onto an irregular shaped piece of white coral. The coral is mounted onto a 7 inch square piece of translucient piece of

» read more | login or register to post comments

Cedar on Base, wire tree sculpture

Sal Villano - Monday, December 28, 2009 - 1:53pm

10" X 11" X 8" Made of 24 and 26 gauge galvanized steel wire. The tree
is planted into a brass 4" round top base using sea sand and pebbles.
The sea sand is painted in yellows and greens using India ink to look

» read more | login or register to post comments