one bend stairs

Giusseppe - Tuesday, July 1, 2008 - 12:42am

» login or register to post comments | thumbnail

Stairway

Nic East - Tuesday, July 1, 2008 - 12:11pm

What are the treads made from? I like what you did with the balusters, giving the same offset. Do you do CADD drawings or fly by the seat of your anvil?

Nic East, Jim Thorpe, PA USA
Creativity begins with a novel thought.

» login or register to post comments

freestyle

Giusseppe - Tuesday, July 1, 2008 - 1:08pm

this was made years ago before computers were available to me
the stringers were made from 2 inch square bar fullered at regular intervals and folded on the weakened spot. I then welded inside the fold to stop them opening with the accumulated weight.
The treads are made from checker plate which has the same lozenge shape on the surface as appears in each fold.
what makes this more complex is the fact that the staircase curves through about 90 degrees from bottom tread to landing.

» login or register to post comments