Bottom of "flower vase"

Pipe vase in progress. Started with an 8" piece of 2" ID Type L copper pipe. Neck it down and then tapered both ways from where necked down. Not through yet, still have to make a couple more rounds getting the tapers smooth....then soldering on a bottom and a patina.

I recently completed this candlestick. Its fabricated hollowform construction in copper married with sterling silver.

This texture is hammer finished, fold formed shallow dish. The fun starts with the curves. Brad

this a bad pic of a bull, ya think? no bull! it,s supposed to be a bull. you must admit it kinda looks like a one or somewhat.comments welcome both nice and not.16ga cr sheet ,18ga bronze, 1/4 round bar, acid dipped just a little and urethane cleared.