ArtMetal

OK, so I decided to try creating a new thread to see if posting info on it would be easier.

I just looked into photo etching not too long ago, so I'm no expert and won't offer much advice but here are some sites I found on the subject.

This is a site dedicated to electro etching, I emailed him with questions and he was very helpful and friendly. He'd probably know what the heck is going on.

http://www.greenart.info/galvetch/contfram.htm

Another site on electroetching

http://steampunkworkshop.com/electroetch.shtml

Here is a site with resists in case that is the problem

http://www.squaredot.com/PROD3.html

Hope these help

From reading your last post, it sounds like there is some issue with the dpi from the image file to the printed output. If the image was printing out at 600 dpi instead of 150 would you end up with the same problem?

Jake