Thanks Jake!
The reason for the z axis door was to allow the door to seal tightly against the forge frame, but still be able to travel up and down easily without abrading the insulation off the door. I couldn't figure out a way to hang the door and still have it seal against the forge frame.
The burners I bought from E&R Enterprises in Smithville, GA (hybridburners.com). They are the 3/4" T-Rex burners that are really unlike anything I have seen before in terms of efficiency and heat output. They are propane burners (can't get natural gas here).
Rob
Thanks Jake! The reason for
Thanks Jake!
The reason for the z axis door was to allow the door to seal tightly against the forge frame, but still be able to travel up and down easily without abrading the insulation off the door. I couldn't figure out a way to hang the door and still have it seal against the forge frame.
The burners I bought from E&R Enterprises in Smithville, GA (hybridburners.com). They are the 3/4" T-Rex burners that are really unlike anything I have seen before in terms of efficiency and heat output. They are propane burners (can't get natural gas here).
Rob