ArtMetal

depending on how thick your work is probably about 1/4 or 3/16, i would use a #1 TIP WITH OX&ACT SET AT 2 AND 2.A NICE SLOW FLOW.heat your material to cherry red touch your rod to it let it flow then flow it out.Clean with wire brush prior to brazing,use 3/32 or 1/8 rod prefluxed or silibronze u still need flux.always wear a resperator and shade #4 lens when brazing and do not overheat.when your material gets red move in with your stick u will get a feel for if u can already weld. hope that helped ya.