Posted by Jimbo on October 06, 1997 at 17:26:31:

I'm new to this site and to metal working. Whats the best way to cut a large number of pieces of steel plate .133" thick x 1/2" wide. I have been using a small cut off wheel on an air grinder, this works but is slow and expensive. Should I use a cutting torch, large cut of saw or try to buy a small hand shear.

Any advise will be greatly appreciated.

Jimbo

rambler@golden.net

Follow Ups:

• Re: Cutting: R Grosse 2/08/98 (1)
  • Re: Cutting: b p fink 2/09/98 (0)
• Re: Cutting: Chris Ray 10/06/97 (2)
  • Re: Cutting: Peter Ferro 10/19/97 (1)
    • bandsaw steve 12/31/97 (0)