Posted by R Grosse on February 08, 1998 at 18:21:08:

In Reply to: Cutting: posted by Jimbo on October 06, 1997 at 17:26:31:

: I'm new to this site and to metal working. Whats the best way to cut a large number of pieces of steel plate .133" thick x 1/2" wide. I have been using a small cut off wheel on an air grinder, this works but is slow and expensive. Should I use a cutting torch, large cut of saw or try to buy a small hand shear.

: Any advise will be greatly appreciated.

: Jimbo

: rambler@golden.net

• Metal Shear Cutting

Follow Ups:

• Re: Cutting: b p fink 2/09/98 (0)