Re: iron marble

ArtMetal
Bramblebush


Bramblebush ForumsFAQ

Posted by Jesse Brennan on October 22, 19100 at 07:29:16:

In Reply to: Re: iron marble posted by Annette Heiberg on October 07, 19100 at 00:43:37:

Hi Annette

Your lost foam should work out great based on what I saw at HIP.

You would probably best use bronze brazing rod rather than scrap to braze in a bronze design. You might also try, in addition to rather than instead of, sinking copper wire into the surface of the foam ball . I think it probably will just get traped in place. You would want to use heavier copper such as the bare #8 or bigger used for electrical grounds. You have enough metal up there to try several ideas. Maybe again next year.

Jesse


Follow Ups:


Bramblebush ForumsFAQ