Re: coring lead

ArtMetal
Bramblebush


Bramblebush ForumsFAQ

Posted by ruth on July 21, 19100 at 05:09:51:

In Reply to: Re: coring lead posted by bpfink on July 20, 19100 at 08:00:42:

hmmm. not much tooth on a balloon i am afraid (i have cast from a real balloon in the first place) and it has to be lead as the lead balloon pun is intended. I think in the short term it may be easier to stick with coring and drilling which works, i just need to be a bit more careful about marking the cast's surface when i am doing it. I will have to have a go at the slush casting though but may start on something smaller I think!. Thanks for the ideas though, i have printed them off and kept them for the future.

ruth


Follow Ups:


Bramblebush ForumsFAQ