Re: Insert molding?... Casting a steel rod in aluminum

ArtMetal
Bramblebush


Bramblebush ForumsFAQ

Posted by Don Buchan on September 03, 1999 at 15:03:12:

In Reply to: Insert molding?... Casting a steel rod in aluminum posted by Rob Frink on September 02, 1999 at 21:24:41:

I do it all the time and haven't run into any problems, I can think of. I use it to leave holes the exact size I need. I just coat the steel pin with sout from my acyetlene torch and then they can be pressed or hammered out using a little pentrating oil.

Don


Follow Ups:


Bramblebush ForumsFAQ