Posted by Lyle Landstrom on November 06, 19100 at 17:13:10:

In Reply to: Re: pour finish on aluminum. posted by John T on November 05, 19100 at 22:24:00:

Is your plaster mold vented properly?

Did you cook the mold enough to drive out the water?

Are you pouring at the correct temp - not too hot?

Is your mold preheated prior to pouring?

Good luck

Lyle

Follow Ups:

• Re: pour finish on aluminum. John T 11/06/100 (0)
• Re: pour finish on aluminum. John T 11/06/100 (7)
  • Re: poor finish on aluminum. John Odom 11/07/100 (6)
    • Re: poor finish on aluminum. john t 11/07/100 (5)
      • Re: poor finish on aluminum. John Odom 11/08/100 (4)
        • Re: poor finish on aluminum. Jesse Brennan 11/08/100 (2)
          • Re: poor finish on aluminum. John T 11/08/100 (0)
          • Re: poor finish on aluminum. John T 11/08/100 (0)